MHF 400/190E1

This machine, with a clamping force of 1900kN, the original MAPLAN FIFO rubber injection unit and a full hydraulic clamping unit represents the middle-sized of the special MAPLAN O-ring series, which is ground-breaking in production of high-precise, flash-less parts in a fully automated environment.

Machine equipment

Standard equipment: Options:

• Microprocessor-control PC5000touch

• Linear positioning system for clamp and injection unit,

ejector injection and clamp side

• Energy saving hydraulic pump with proportional

pressure/flow control

• 2-circuit-cooling unit (Thermo oil) for

plasticizing cylinder and injection pot

• Oil filter-, oil level- and oil temperature monitoring

• Visualization via height adjustable operation desk

• Strip intake control

• Central ejector

• Reduced centering diameter

• High-precise injection units

• Optimized heating cartridges, 3-zone heating plates

control with solid state relays

• Reinforced heating- and machine plates, spars,

insulating plates

• Hydraulic ejector injection and/or clamp side

• Heating and cooling devices for plasticizing cylinder,

injection pot, screw or cold runners

• Vacuum pump

• Microprocessor control features for PC5000touch

• Pneumatic safety gate front side

• Alternative injection volumes

• Additional mould heating zones

• Magnetic clamping system

• Brush devices single / double - and/or knockout devices

• Automatic strip intake device

• Power factor correction

Technical data/Dimensions:

Clamping unit			Electric equipment
Opening stroke	mm	450	Motor rating	kW	15
Opening between plates	mm	550	Heating plates	kW	9,4
Clamping force	kN	1909	Control voltage	V	24 V=
Opening force	kN	59	Connected load°	kW	26,6
Clamping speed fast	mm/sec	500	Machine weight	kg	5700
Opening speed fast	mm/sec	350
Hydraulic central ejector stroke	mm	90
Min. mould height	mm	100

Hydraulic unit
System pressure	bar	280
Pump output	l/min	68

Injection units		130	200	400	530	750
Max. injection volume	cm³	130	200	400	530	750
Max. injection pressure	bar	1845	2520	1945	1465	1900
Max. injection capacity	cm³/sec	50	76	115	92	120
Screw diameter	mm	27	27	27	27	32
Screw ratio	L/D	13 D	13 D	10 D	10 D	10 D
Max. Screw speed	rpm	220	220	220	220	200
Plasticizing capacity	cm³/min	400	650	400	400	600
Temperature zones		3	3	3	3	3

° without additional heating and cooling/heating devices

values for 50Hz, subject to technical modifications

There are available options like brush devices, Logical movements, Cure² and further more.
For further Information please complete the contact form.