MTF 1500/250

This machine with a clamping force of 2500kN, the original MAPLAN FIFO rubber injection unit and a full hydraulic clamping unit represents the middle-sized version of the MAPLAN vertical machine series, which is ground-breaking in production of rubber-combination parts in manual or fully automated configuration.

Machine equipment

Standard equipment: Options:

• Microprocessor-control PC5000touch

• Linear positioning system for clamp and injection unit,

ejector injection and clamp side

• Energy saving hydraulic pump with proportional

pressure/flow control

• 2-circuit-cooling unit (Thermo oil) for

plasticizing cylinder and injection pot

• Oil filter-, oil level- and oil temperature monitoring

• Visualization via height adjustable operation desk

• Strip intake control

• Pneumatic safety gate front side

• Hydraulic ejector injection and/or clamp side

• Heating and cooling devices for plasticizing cylinder,

injection pot, screw or cold runners

• Vacuum pump

• Microprocessor control options for PC5000touch

• Alternative injection volumes

• Additional mould heating zones

• Magnetic clamping system

• Shuttle front side

• Shuttle rear side

• Central ejector

• Hydraulic sliding plates

• Light shield

• Automatic strip intake device

• Power factor correction

Technical data/Dimensions:

Clamping unit			Injection units		1500	2000
Opening stroke	mm	500	Max. injection volume	cm³	1500	2000
Opening between plates	mm	700	Max. injection pressure	bar	1980	1485
Clamping force	kN	2500	Max. injection capacity	cm³/sec	115	150
Opening force	kN	74,6	Screw diameter	mm	42	42
Clamping speed fast	mm/sec	500	Screw ratio	L/D	9 D	9 D
Opening speed fast	mm/sec	260	Max. Screw speed	rpm	180	180
Min. mould height¹	mm	200	Plasticizing capacity	cm³/min	1250	1250
Min. mould height²	mm	130	Temperature zones		3	3

Electric equipment			Hydraulic unit
Motor rating	kW	15	System pressure	bar	220
Heating plates	kW	14	Pump output	l/min	68
Control voltage	V	24 V=
Connected load°	kW	31
Machine weight	kg	9000

° without additional heating and cooling/heating devices
¹ Min. mould height without sliding plate
² Min. mould height with sliding plate

values for 50Hz, subject to technical modifications

There are available options like brush devices, Logical movements, Cure² and further more.
For further Information please complete the contact form.