MTF 1500/280ergonomic

This machine with a clamping force of 2800kN, the original MAPLAN FIFO rubber injection unit in classic or ergonomic version and a full hydraulic clamping unit with ergonomic working height, represents the smallest version of the new “ergo” machine series, which is ground-breaking in production of high-precise parts in manual or fully automated configuration.

Machine equipment

Standard equipment: Options:

• Microprocessor-control PC5000touch

• State of the art PLC controller in multitasking,

time constant control algorithms

• Full digital control of movements, temperatures and

other process parameters

• Electronic linear positioning system for clamp and

injection unit

• 5 temperature control zones

• Control panel for manual operation

• Energy saving hydraulic pump with proportional

pressure/flow control

• 2-circuit-cooling unit (thermo oil) for plasticizing cylinder

and injection pot

• Oil filter-, oil level- and oil temperature monitoring

• Light shield front side

• Solid state relays for heating zones

• Hydraulic ejector injection side and/or

clamp side, linear positioning system

• Heating and cooling devices for plasticizing cylinder,

injection pot, screw or cold runners

• Vacuum pump

• Microprocessor control features for PC5000touch

• Shuttle front or rear side

• Double shuttle

• Brushing device upper and/or lower side for shuttle

• Alternative injection volumes

• Additional mould heating zones

• Automatic strip intake device

• Light shield rear side

• Sliding plates

• Power factor correction

Technical data/Dimensions:

Clamping unit			Electric equipment
Working height	mm	820	Motor rating	kW	15
Opening between plates	mm	799	Heating plates	kW	14
Clamping force	kN	2835	Control voltage	V	24 V=
Opening force	kN	55,3	Connected load°	kW	31
Clamping speed	mm/sec	470	Machine weight	kg	7500
Opening speed	mm/sec	420
Max. mould height	mm	557
Min. mould height	mm	200

Hydraulic unit
System pressure	bar	250
Pump output	l/min	68

FIFO injection units		1500	2000	2500	3200
Max. injection volume	cm³	1500	2000	2500	3200
Max. injection pressure	bar	1980	1485	1917	1500
Max. injection capacity	cm³l/sec	115	150	120	155
Screw diameter	mm	42	42	52	52
Screw ratio	L/D	9 D	9 D	9 D	9 D
Max. Screw speed	rpm	180	180	105	105
Plasticizing capacity	cm³l/min	1250	1250	1050	1050
Temperature zones		3	3	3	3

° without additional heating and cooling/heating devices

values for 50Hz, subject to technical modifications

There are available options like brush devices, Logical movements, Cure² and further more.
For further information please complete the contact form.