MTF 2500/400

This machine with a clamping force of 4000kN, the original MAPLAN FIFO rubber injection unit and a full hydraulic clamping unit represents the largest version of the MAPLAN vertical machine series, which is ground-breaking in production of rubber-combination parts in manual or fully automated configuration.

Machine equipment

Standard equipment: Options:

• Microprocessor-control PC5000touch

• Linear positioning system for clamp and injection unit,

ejector injection and clamp side

• Energy saving hydraulic pump with proportional

pressure/flow control

• 2-circuit-cooling unit (Thermo oil) for

plasticizing cylinder and injection pot

• Oil filter-, oil level- and oil temperature monitoring

• Visualization via height adjustable operation desk

• Strip intake control

• Pneumatic safety gate front side

• Hydraulic ejector injection and/or clamp side

• Heating and cooling devices for plasticizing cylinder,

injection pot, screw or cold runners

• Vacuum pump

• Microprocessor control options for PC5000touch

• Alternative injection volumes

• Additional mould heating zones

• Magnetic clamping system

• Shuttle front side

• Shuttle rear side

• Central ejector

• Hydraulic sliding plates

• Light shield

• Automatic strip intake device

• Power factor correction

Technical data/Dimensions:

Clamping unit			Electric equipment
Opening stroke	mm	580	Motor rating	kW	45
Opening between plates	mm	830	Heating plates	kW	25,8
Clamping force	kN	4120	Control voltage	V	24 V=
Opening force	kN	128,7	Connected load°	kW	74
Clamping speed fast	mm/sec	500	Machine weight	kg	14200*
Opening speed fast	mm/sec	320
Min. mould height¹	mm	250
Min. mould height²	mm	180

Hydraulic unit
System pressure	bar	210
Pump output	l/min	130

Injection units		2500	3200	4000	5300
Max. injection volume	cm³	2500	3200	4000	5300
Max. injection pressure	bar	1917	1500	1900	1426
Max. injection capacity	cm³l/sec	215	275	210	280
Screw diameter	mm	52	52	68	68
Screw ratio	L/D	9 D	9 D	10 D	10 D
Max. Screw speed	rpm	186	186	122	122
Plasticizing capacity	cm³l/min	1900	1900	2000	2000
Temperature zones		3	3	3	3

*15500 kg at 4l/5,3l

° without additional heating and cooling/heating devices
¹ Min. mould height without sliding plate
² Min. mould height with sliding plate

values for 50Hz, subject to technical modifications

There are available options like brush devices, Logical movements, Cure² and further more.
For further Information please complete the contact form.