MTF 400/80

This machine with a clamping force of 800kN, the original MAPLAN FIFO rubber injection unit and a full hydraulic clamping unit represents the smallest version of the MAPLAN vertical machine series, which is ground-breaking in production of rubber-combination parts in manual or fully automated configuration.

Machine equipment

Standard equipment: Options:

• Microprocessor-control PC5000touch

• Linear positioning system for clamp and injection unit,

ejector injection and clamp side

• Energy saving hydraulic pump with proportional

pressure/flow control

• 2-circuit-cooling unit (Thermo oil) for

plasticizing cylinder and injection pot

• Oil filter-, oil level- and oil temperature monitoring

• Visualization via height adjustable operation desk

• Strip intake control

• Pneumatic safety gate front side

• Hydraulic ejector injection and/or clamp side

• Heating and cooling devices for plasticizing cylinder,

injection pot, screw or cold runners

• Vacuum pump

• Microprocessor control options for PC5000touch

• Alternative injection volumes

• Additional mould heating zones

• Magnetic clamping system

• Shuttle front side

• Shuttle rear side

• Central ejector

• Hydraulic sliding plates

• Light shield

• Automatic strip intake device

• Power factor correction

Technical data/Dimensions:

Clamping unit			Injection units		400	530
Opening stroke	mm	400	Max. injection volume	cm³	400	530
Opening between plates	mm	470	Max. injection pressure	bar	1945	1465
Clamping force	kN	840	Max. injection capacity	cm³/sec	75	100
Opening force	kN	36	Screw diameter	mm	27	27
Clamping speed fast	mm/sec	700	Screw ratio	L/D	10 D	10 D
Opening speed fast	mm/sec	400	Max. Screw speed	rpm	220	220
Min. mould height¹	mm	70	Plasticizing capacity	cm³/min	400	400
Min. mould height²	mm	40	Temperature zones		3	3

Electric equipment			Hydraulic unit
Motor rating	kW	7,5	System pressure	bar	210
Heating plates	kW	6	Pump output	l/min	42
Control voltage	V	24 V =
Connected load°	kW	16
Machine weight	kg	4000

° without additional heating and cooling/heating devices
¹ Min. mould height without sliding plate
² Min. mould height with sliding plate

values for 50Hz, subject to technical modifications

There are available options like brush devices, Logical movements, Cure² and further more.
For further Information please complete the contact form.